CLAS OE 2040 Mode D'emploi page 8

OE 2040
MULTICHARGER STATION 4 CHANNEL
SAFETY
1. SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions for battery
charger/maintainer Model OE 2040.
2. Use OE 2040 only on 12 volts LEAD ACID, AGM and GELLED ELECTROLYTE (GEL-CELL) batteries. Do
not attempt to use on other voltages and types of batteries (DRY CELL, NICKEL CADMIUM, NICKEL METAL
HYDRIDE, etc.) commonly found in small home appliances. This may cause OE 2040 and batteries to burst,
resulting in damage or injury to person and property. OE 2040 delivers up to 5 Amps.
3. Do not expose OE 2040 to direct sunlight, rain or snow.
4. Do not use OE 2040 on batteries that are in use or that are installed. If necessary to remove batteries from
the vehicle and take to a properly installed OE 2040 location.
5. Do not use attachments with the OE 2040 that are not recommended. Non-recommended attachments may
result in injury, electric shock, or re and voids the warranty.
6. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting charger.
7. An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result
in a risk of re and electric shock.
8. Do not operate charger with damaged cord or plug – replace the cord or plug immediately.
9. Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way;
take it to a quali ed serviceman.
10. Do not disassemble charger; take it to a quali ed serviceman when service or repair is required. Incorrect
reassembly may result in a risk of electric shock or re
11. To prevent injury during cleaning or maintenance, disconnect all batteries and move them to clear access
to the unit. Unplug OE 2040 from the wall outlet. Use a slightly dampened cloth to clean the housing and lead
sets. Do not use solvents or soaps.
12. Place the power cords in a location where they will not be stepped on, tripped over, or subjected to stress
or abuse of any kind.
13. For fuse replacement, contact distributors for replacement. Any tampering or incorrect assembly may result in
re or electric shock and voids the warranty.
14. Never attempt to charge a frozen battery. Allow the battery to return to room temperature before connection.
Suggested operation range is in ambient temperature.
15. Never use OE 2040 in or on any boat or watercraft. You must remove the battery from the boat or
watercraft and charge the battery at the properly installed location of OE 2040 unit.
16. Do not install OE 2040 where it will be exposed to moisture or inclement weather, or around combustibles
like trash, ammable liquids and vapors.
WARNINGS – RISK OF EXPLOSIVE GASES
1. Working in the vicinity of a lead acid battery is dangerous. Batteries generate explosive gases during normal
battery operation. For this reason, it is of utmost importance that each time before using your OE 2040, you
read this manual and follow the instructions exactly.
2. To reduce risk of battery explosion, follow these instructions and those published by the battery manufacturer
and manufacturer of any equipment you intend to use in the vicinity of the battery. Observe cautionary markings
on these items.