Using The Blower - Jonsered B2126 Manuel D'utilisation

To blow away debris on the
ground
Fitting the blower tube and nozzle
on the blower
WARNING:
When fitting the blow-
er tube and nozzle, the engine must
be switched off.
The blower tube (T) has a pegged slot
mounting system to the unit. To install or
remove the blower tube (or collection bag
tube for BV2126), the tube clamp bolt must
be removed. Align slot in the blower air out-
let with the raised rib on the tube and insert
tube until the holes in the tube and housing
align. Re- -insert the tube clamp bolt and
tighten.
T
The nozzles (U) have a bayonet mount
for connection to the blower tube. Air is
channeled through the blower tube to the
nozzles, where the air discharge velocity
increases and the air stream discharge
pattern is formed to provide best perfor-
mance. The length of the blower tube can
be adjusted by twisting the nozzle to the left
to disengage the bayonet mount and sliding
the nozzle to the appropriate position.
Twist the nozzle to the right until a click is
felt to re- -secure the nozzle.
Blowing
Before you begin blowing, put on the re-
quired safety equipment.
WARNING:
When working with
the blower, wear the required per-
sonal safety equipment:
1. Hearing protection.
2. Eye protection.
3. Protective gloves.
4. Face mask in dusty environments.
545154659 Rev. 10 3/15/12

USING THE BLOWER

BV2126 can be used with a shoulder strap
for extra comfort. The strap should be
worn over the shoulder as shown.
U
WARNING:
nozzle at people or animals. The
high- - velocity air stream can contain
particles that may cause serious
injury, especially if the blower has
previously been used for vacuuming.
Be careful, particularly if left hand
operation is applied. Avoid any di-
rect body contact with inlet cover
area. Keep jewelry, loose clothing,
or clothing with loosely hanging
straps, ties, tassels, etc., away from
inlet cover area.
Never point the blower
English--- 13