Battery Replacement - IDEAL SureTrace 61-955 Mode D'emploi

3) Plug the clamp into the battery pack.
4) Set the receiver to the highest sensitivity (
Receiver is saturated, reduce the sensitivity range.
Tracing industrial control circuits.
1) Ensure that the circuit is energized (closed at the panel) at a minimum. To maximize the
signal, close the other end of the circuit by turning on a load, such as a motor or pump.
2) Clamp around the hot wire of this energized (closed) circuit.
3) Use the magnetic strap to hang the battery pack onto the panel or the motor control
cabinet.
4) Plug the clamp into the battery pack.
5) Set the receiver to the highest sensitivity (
end. If the receiver is saturated, reduce the sensitivity mode.

Battery Replacement

Note: Use only good quality alkaline batteries for maximimum operating life.
Always replace with a complete set of new batteries of the same type.
Remove batteries as soon as they become exhausted to avoid
damage due to leakage.
Transmitter:
Ensure that the test leads are removed from the output
jacks and the circuit under test.
1) Remove the battery cap by loosening the screw.
2) Replace batteries with (4) new AA batteries.
3) Re-fit cap and re-tighten the screw.
) mode and trace the conduit. If the
) mode and trace the circuit to the other
Page 20