Lcd Display; Waste Disposal - cedamatic CP.GLISS 2500 OTIC Mode D'emploi

The LCD display can be turned by 180°.
- Cut off mains power supply
- Press OK
- While keeping OK pressed, reset the mains power supply
- Keep OK pressed (around 5 sec) until the software version appears, turned by 180°.
Normally proceed with programming.
In the event of malfunctions, by pressing key + or - the status of all inputs (limit switches, control and safety) can be displayed. One
segment of the display is linked to each input. In the event of failure it switches on according to the following scheme.
If the product must be dismantled, it must be disposed according to regulations in force regarding the differentiated waste disposal and
the recycling of components (metals, plastics, electric cables, etc..). For this operation it is advisable to call your installer or a specialised
company.

LCD DISPLAY

DIAGNOSTICS
SWO SWC PHO3 PHO4
P.P. PED OPEN
PHO1 PHO2 STOP DAS

WASTE DISPOSAL

CLOSE
23