Installation; Installing The Mounting Brackets; Installing The Product - Glacier bay 65415W-6A01 Guide D'installation Et D'entretien

Installation

1
Marking the mounting location
□
Remove the set screw (DD) from the base of the
product posts.
□
Place the product in the desired mounting
location, using a level to position it accordingly,
and use a pencil to lightly mark the outline of the
posts.
□
Center the mounting bracket (BB) within the
marked post locations, and mark where the
screw holes will be drilled.
□
Repeat this step as needed for each bath
accessory.
NOTE: The included template (EE) may be used to mark the
mounting locations for the towel bars: A and C for the 18
in. towel bar/ A and D for the 24 in. towel bar or double towel
bar.
3

Installing the product

□
Place the post (A, C, E, or F) over the mounting
bracket (BB) and secure it with the set
screw (DD), as shown.
□
Repeat this step for the remaining
post (A, C, E, or F).
NOTE: Ensure the towel bar (B or D) is inserted prior to
securing the second post (A, C, E, or F) to the mounting
bracket (BB).
DD
BB
2

Installing the mounting brackets

□
Drill 1/4 in. holes in the previously marked
locations.
□
Push the plastic anchors (CC) flush into the dry wall.
□
Fasten the mounting bracket (BB) to the wall with
the wood screws (AA).
□
Repeat this step as needed for each bath
accessory.
NOTE: When mounting the products to a wood wall, fasten
the mounting brackets (BB) to the wall using the wood
screws (AA). There will be no need for drilling or plastic
anchors (CC).
5
Please contact 1-855-HD-GLACIER for further assistance.
CC
AA
BB
AA
BB
BB
DD
HOMEDEPOT.COM