Troubleshooting Guide; Specifications - Kenwood KCA-BT100 Mode D'emploi

Troubleshooting Guide

What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
?
The hands-free talk volume is low.
✔ The hands-free talk volume is set at a low level.
☞ The hands-free talk volume can be adjusted
independently. Adjust it during hands-free talk.
?
No sound is heard from the rear speakers.
✔ You are talking in the hand-free talk mode.
☞ No sound is heard from the rear speakers in the
hands-free talk mode.
?
No beep is heard at reception of an incoming call.
✔ No beep is heard depending on the type of your
cell-phone.
☞ Selecting "Call Beep: ON" or "C-BP ON" (page 11),
or "Beep On" (page 16) allows you to hear the
beep.
?
Characters in a name are missing.
✔ The control unit cannot display accent characters.
☞ Set the display character conversion function
switch to "2" (page 18).
?
The name of the cell-phone is not displayed.
✔ When registering a cell-phone, the address may be
displayed instead of the name of the cell-phone.
☞ Turn off the power of the control unit and on
again. The name of the connected cell-phone
will be displayed.

Specifications

Specifications subject to change without notice.
Bluetooth section
Technology
: Bluetooth 1.2 Certified
Frequency
: 2.402 – 2.480 GHz
Output Power
: +4dBm (MAX), 0dBm (AVE) Power Class 2
The messages shown below display your
systems condition.
No Number/ NO-NMBER/ Incoming No Number :
• The calling party does not notify a caller ID.
• There is no phone number data.
No Data/ NO DATA :
• There is no outgoing call list.
• There is no incoming call list.
No Entry/ NO ENTRY :
The cell-phone has not been registered (pairing).
Disconnect/ DISCONCT/ Non Connection/ Disconnected :
The unit cannot communicate with the cell-phone.
Connect/ CONNECT :
The unit can communicate with the cell-phone.
HF Error 07/ HF ERR07:
The memory cannot be accessed.
\ Turn off the power and on again. If this message still
appears, press the reset button on the control unit.
HF Error 68/ HF ERR68:
The unit cannot communicate with the cell-phone.
\ Turn off the power and on again. If this message still
appears, press the reset button on the control unit.
General
Operating voltage (11 – 16V allowable)
: 14.4 V
Current consumption
: 0.2 A
Dimension (W × H × D)
: 95 × 30 × 105 mm
3-3/4 × 1-3/16 × 4-1/8 inch
Weight
: 0.78 lbs (0.35 kg)
21
|
English