Connection Of Accessories; Cleaning Floors - POLTI Vaporetto SV440 Double Manuel D'instructions

Open the cap of the tank by pulling it outward
(2), then fill the tank with water.
Do not add other substances or additives to
the tank.
Close the cap of the tank and reattach it to
the appliance.
This operation must always be carried out
with the power cable disconnected from the
mains.
1.3 The appliance is ready in Portable Steam
Cleaner mode.
2. PREPARATION FOR STEAM
BROOM USE
2.1 Connect the Portable Steam Cleaner to the
brush, matching the pin on the brush with the
hole on the appliance (3).
2.2 Insert the hose with the handle into the
specific opening on the appliance (4A),
making sure that the pin on the hose lines up
with the hole on the appliance. To remove it,
press the button located on the tank (4B) and
pull upward.
2.3 The SV440_Double model has a dispen-
ser, located behind the floor brush, to be used
exclusively with FrescoVapor, the natural deo-
dorant that, besides leaving a pleasant fra-
grance, also captures bad smells. To use Fre-
scoVapor, proceed as described in Chapter 12.
2.4 Unwind the power cable completely and
connect it to an appropriate socket (5) that is
earthed.
Always use the product with the cable com-
pletely unwound.
The power indicator light will come on (red) lo-
cated around the steam adjustment knob (6).
Wait until the "steam ready" indicator light
comes on (around 15 sec., green). At this point
the appliance is ready.
Before starting the steam cleaning, it is good
practice to have previously swept or vacuumed
the floor or the surface to be cleaned.

3. CONNECTION OF ACCESSORIES

The accessories can be connected directly to
the Portable Steam Cleaner or to the flexible
hose for greater freedom of movement.
3.1 To connect the accessories directly to the
Portable Steam Cleaner just insert them on
the point and turn them until they lock (9).
3.2 FLEXIBLE HOSE
To connect the flexible hose to the portable
cleaner, the adapter must first be connected to
the cleaner (7), after which connect the flexible
hose to the adapter and turn it clockwise until
a click is heard (8). To remove the flexible ho-
se from the adapter, pull the lever located on
the connection of the hose and rotate it in the
opposite direction.
• To connect the various accessories to the
flexible hose, the lance must first be moun-
ted on the tube.
3.3 LANCE
The lance can be connected to the portable
cleaner with the adapter, or to the flexible ho-
se.
To connect it, just attach the lance to the
adapter or the flexible hose and then rotate
the lance in the direction indicated by the ar-
row (10).
The following accessories can be attached to
the lance:
• Brush with window-cleaner accessory, con-
centrator, brushes and grout accessory.
Just insert them on the point of the lance
and turn them until they lock (11).
4. STEAM ADJUSTMENT
You can optimise the steam flow by means of
the steam adjustment knob (12). You can in-
crease the steam flow by turning the control
in a clockwise direction. Turning it in an anti-
clockwise direction reduces the steam flow.
Here are some suggestions for the choice of
steam flow level:
•Maximum level : to remove scaling, stains,
grease;
•Medium level: to clean windows, floors and
clean and brighten rugs and carpets;
•Minimum level: to clean parquet and lamina-
te, delicate fabrics, upholstery, sofas and
mattresses, etc. and to steam plants.

5. CLEANING FLOORS

Before using the appliance on delicate surfa-
ces, ensure that the part in contact with the
surface is free from foreign bodies that
could cause scratches.
Before starting the steam cleaning, it is good
practice to have previously swept or vacuu-
med the floor.
| 25 |