Handset Module 20-/21-1104 Configuration - Telecom Behnke 20-1104 Manuel

Analogue / IP electronics add-on handset
GB GB
Configuration and Set-up

3.2. Handset module 20-/21-1104 configuration

The following demonstrates configuration step 970 to start using the handset on your Behnke door
intercom. For further configuration steps, please see the user manual available for download at
www.behnke-online.de/download.
Code Parameter (see below for details)
970 Operations mode T2 key:
Hookswitch for handset operation (from V1.30):
Connecting a handset will result in the T2 key being used as a
hookswitch. The hookswitch signals picking up and hanging up of the
handset to the door intercom. Picking up the handset during a connected
call will result in the hands-free mode being terminated and instead
the handset's microphone and speaker will be turned on. When set to
operations mode 4, picking up the handset will result in a direct call (T2
key), in operations modes 5 and 6 picking up the handset will enable
the door intercom's telephone function and a telephone number may
be dialled from a connected number keypad. In operations mode 6, the
direct call keys may be used as speed dial keys, i.e. pressing a speed dial
key will result in dialling the telephone number saved for this key. You do
not need to hang up before making such a call, unless you have already
started to enter a telephone number via the connected number keypad.
In operations mode 7 (available in V1.42 and later) picking up the hand-
set will activate the speed dial function.
Please note:
When the operations mode has been changed and after you have left the
set-up mode, you should always reboot your door intercom, because it
is sometimes necessary to reboot the door intercom for the operations
mode to be set correctly.
* 0000 (default setting)
Enter set-up mode
900 1
Enabling advanced set-up
This configuration step must be carried out in order to perform the
extended configuration.
970 4 (hookswitch)
Handset operation with direct call function: The device will dial the
number saved in step 22 as soon as the handset has been picked up.
970 5 (hookswitch)
Handset operation with telephone function: Dial via the number keypad
970 6 (hookswitch)
Handset operation with telephone function and speed dial function:
Dial via the number keypad or via speed dial keys
19
Confirmation
default: 0
#
#
#
#
www.behnke-online.com