Unpacking; Disposal Of The Packaging; Setup Location Requirements - Braukmann CASO DESIGN Grande Aroma 100 Mode D'emploi

Machine à café électrique avec moulin broyeur
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 49
► Immediately notify the carrier, the insurance and the supplier about any incomplete
shipment or damages as a result of inadequate packaging or due to transportation.

12.3 Unpacking

To unpack the device, proceed as follows:
 Remove the device out of the carton and remove the packaging material.

12.4 Disposal of the packaging

The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and recycling-
related points of view and can therefore be recycled. Returning the packaging back to the
material loop saves raw materials and reduces the quantities of accumulated waste. Take
any packaging materials that are no longer required to "Green Dot" recycling collection
points for disposal.
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event
of a guarantee claim.

12.5 Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:
 Only use this device on a flat, stable, heat-resistant surface away from water splashes
and any heat sources. Never use the device outdoors and always place in a dry
environment.
 Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
 Do not operate the device under delicate furniture as the escaping steam could damage
them.
 Choose the setup location in such a way that children cannot reach any hot surfaces on
the device.
 The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
 The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
Please note
Please note
36

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

1856

Table des Matières