Installing The Backrest; Folding The Rollator - Thuasne New Design W2230 Notice D'utilisation

4. Installing the backrest
Slide the ends of the backrest downwards into the supports of the
rollator that are provided for that purpose. cf. photo No. 7.
Backrest correctly installed. cf. photo No. 8.
Fasten the backrest by tightening the screws. cf. photo No. 9.
5. Adjusting the height of the handles
Adjust the height of the handles by pressing on the spring-
•
loaded button.
Check that the handles are adjusted to the same height on both
•
sides, and approximately to the height of the wrist bones of the
user when the user's arms are hanging down along the body
with the legs slightly apart and with the shoulders relaxed. cf.
photo No. 10
Photo No. 7
Photo No. 8
Photo No. 9
Photo No. 10
Check the spring-loaded button is properly engaged before using the
rollator. cf. photo No. 11
6. Installing the soft basket:
The soft basket should be installed at the front of the rollator on the
two tubes on either side of the seat. The maximum load that can be
withstood by the basket is 5 kg. cf. photo No. 12.
The ND rollator is now ready for use.
USE
1. Folding the rollator
To fold the rollator up, merely pull on the strap of the seat. Once
folded up, it stays in the upright position by itself.
cf. photos Nos. 13 and 14
Photo No. 13
To facilitate carrying and transport, it
is possible to fold away the rear wheel supports (and the front wheel
supports if necessary).
- 9 -
CLICK !
Photo No. 11
Photo No. 12
Photo No. 14