Checking For Gas Leaks; Burner Operation - Star Max 6115RCBF Manuel D'utilisation

CONVERT TO NATURAL GAS
If your charbroiler is equipped with fixed orifice hoods and is shipped from the factory for use with
propane gas, and you wish to convert to natural gas. Follow these steps, install the burner orifice
hoods, located in the grease drawer, as follows:
. Remove grill, radiants and burners.
2. Remove the burner orifice hoods and install the orifice hoods (not supplied).
3. Replace the burners, radiants, and grill.
4. Set manifold pressure to (6) inch water column. A 1/8" pipe plug on the burner manifold can be
removed for attaching a pressure gauge. Remove the slotted, or hex-threaded plug from the
pressure regulator. Invert the plug and re-install. The letters "NAT" should now be visible on the
plug. The regulator is now set for 6" (15.24 cm) water column.

CHECKING FOR GAS LEAKS

Check entire piping system for leaks. Soap and water solution or other material acceptable for the
purpose shall be used in locating gas leakage.
Matches, candle flame or other sources of ignition shall not be used for this purpose.
CAUTION
PILOT LIGHTING INSTRUCTIONS
The unit is equipped with standing pilots, and should be lit immediately after the gas is turned on.
. Turn off main valve to unit.
2. Turn off all knobs and pilot valves and wait 5 minutes to clear gas.
3. Turn on main valve and light all pilots. The best access to the pilot is obtained from the bottom
with the grease drawer removed.
4. Adjust pilot light flames as small as possible, but high enough to light burner immediately when
burner valve is turned on high.
5. Turn burner knobs to desired setting.
6. To turn burners off, turn knobs off.
SHUTTING DOWN INSTRUCTIONS
Turn the burner valve knobs to the off position to turn burners off.
BURNER IGNITION AND ADJUSTMENT
1. To ignite burners turn burner valve knob to "HI" position.
2. Slowly decrease openings of air shutters on burners to give a soft blue flame having luminous tips,
then slowly increase openings to a point where the yellow tips disappear and a hard blue flame
is obtained.
PLACING LAVA ROCK ON GRATES (FOR 60--CBD SERIES)
Open the lava rock bags and place rock evenly on grates. Do not cover the grates with more than two
layers of lava rock. DO NOT PUT MORE THAN 5 LBS. OF ROCK PER BURNER!
PLACING RADIANTS (FOR 61--RCBD SERIES)
After the unit is unpacked and installed, place 2 radiants above each burner. Install each radiant
engaging the notches on the top assembly. Refer to the exploded view in this manual for orientation
of the radiants.

BURNER OPERATION

Each burner is controlled by an individual high-low, on-off valve. An infinite number of broiling
temperatures may be obtained by turning the burner valve knob to any position between high and
low. It is possible through this arrangement to have a high heat or searing section, while having a low
heat finishing or holding section. For the searing operation, set the valves for the section at a position
of "HI" or close to it. For holding or finishing, set the valves closer to the "LOW" position on the dial.
You select the heat pattern you like, and set the valves accordingly.