Publicité
Les langues disponibles
Les langues disponibles
Power supply
INSTALLATION
• After removing the packaging, make sure that the appliance is intact; in case of doubt, do
not use it and contact professionally qualified personnel. The packaging (plastic bags,
expanded polystyrene, nails, etc.) should not be left within the reach of children as it is a
potential source of danger.
• Before connecting the battery charger, check that the voltage values on the nameplate
correspond to those of the mains. If there is any incompatibility between the socket and
the appliance plug, have the socket replaced by a suitable one by a professionally qualified
person.
• Before each use, check that the battery charger (including the electric cord) and the
scooter are in good condition and are not damaged: in case of doubt, contact
professionally qualified personnel.
• Make sure that the cable is correctly positioned and that it is not in contact with hot parts
or sharp edges, wrapped around the unit or twisted around itself.
• The scooter must be placed on a surface that is stable, wide (shelves are excluded), and
not sloping.
Charging your electric scooter
1.
The scooter must be switched off during charging (display off); if it was previously on,
"
press the
2.
Check that the scooter's charging port is clean and dry.
3.
Insert the pin of the supplied adapter into the port at the bottom of the deck (near the
kick stand) all the way down, and insert the plug into the socket, making sure the red light
"
for about 2 seconds to turn the scooter off.
button
Publicité
