MTD Yard Machines MTD1400K Manuel D'utilisation page 12

For Parts Call 606-678-9623 or 606-561-4983 For Parts Call 606-678-9623 or 606-561-4983
SHREDDING BLADES MAINTENANCE
WARNING:
the machine is switched off, the red safety
switch and extension lead is removed and wait
until the machine comes to a complete stop.
To inspect or replace the double sided shredding blades
there is no need to remove the cutter base. To remove sim-
ply undo the counter sunk screws with the 6mm hex
wrench supplied with the machine and turn them through
180˚ These blades are double ground and can be used on
both sides. When blunt on both sides replace and insure
they are screwed in tightly.
ASSEMBLY This is carried out in the reverse sequence to
that of disassembly but with careful inspection of all com-
ponents. Ensure that cutter base is assembled with the
scraping plates facing down towards the motor and that
the square washer is situated under the head of the cen-
ter hold down bolt. (Fig. 15)
Before replacing the top cover assembly ensure that the V-
cutter is positioned as shown in (Fig. 16) Replace the top
cover assembly and secure tightly the caging knobs. If
caging Knobs are not tight the motor will not start due to the
motor lock out switch not being activated.
CLEANING
After use, always wipe clean the outside of the shredder to
remove any build up of material with a damp cloth. Clean
the inside of the cutting chamber and remove any left over
material, Do not hose down with water.
MAINTENANCE INSTRUCTIONS
Before removing Top
Hopper knob, insure
www.mymowerparts.com www.mymowerparts.com
11
Fig. 15
Fig. 16