Craftsman ZTS 7000 Manuel D'utilisation page 25

Figure 17. Rear Lift Arms
10. Remove the hair pin clips (A, Figure 18) and washers
( ) that secure the front hitch rods (C). Separate the
front hitch rods from the mower deck.
11. Slide the mower deck out from under the rider.
Figure 18. Front Lift Arms
Installation
1. Slide the mower deck under the right side of the rider.
2. Slide the mower deck forward and connect the front
C
3. Slide the mower deck backward and connect the rear
4. Insert the key into the ignition switch. Turn the switch
5. Use the cutting height switch to raise the mower until
6. Turn the ignition switch OFF and remove the key.
A
B
7. Use the mower belt lever (A, Figure 16) to release
C
Mower blades and mower drive belt should come to a
B
complete stop within 5 seconds after electric PTO switch
A
is turned off.
1. With parking brake engaged, PTO disengaged and an
2. Have an assistant observe the mower drive belt
3. If the mower drive belt does not stop within 5 sec-
hitch rods to the mower deck. Secure with washers
( , Figure 18) and hair pin clips (A).
lift arms to the mower deck. Secure with washers ( ,
Figure 17) and hair pin clips (A).
from OFF to RUN without starting the engine.
it is no longer resting on the 4x4 wood blocks.
Remove the 4x4 blocks.
belt tension, and install the mower belt ( ) as shown.
WARNING
To avoid serious injury, perform adjustments only
with engine stopped, key removed and rider on
level ground.
¾»¹Á ÅÍ»È Â·º» ÊÅÆƿĽ ¿Ã»
operator in the seat, start the engine.
through the opening between the frame and top of
mower deck. Engage the PTO and wait several sec-
onds. Disengage the PTO and check the amount of
time it takes for the mower drive belt to stop.
onds, see an authorized dealer.
25