Adjustments And Service; Ground Speed Lever Adjustment - Craftsman ZTS 7000 Manuel D'utilisation

Tracteur à braquage zéro à démarrage électrique

Table des Matières

Seat and Ground Speed Lever Adjustments

The seat and ground speed levers should be adjusted

so that operator's elbows are supported by the arm rests

when his/her hands are on the controls, and the ground

speed levers can be moved through their full range of

motion without contacting the operator's legs.

Seat Position Adjustment

Lift the seat adjustment lever (A, Figure 12). Slide the

seat forward or backward to the desired position, then

lower the seat adjustment lever. Make sure the lever

locks into the locking slots ( ) in the seat base.

Figure 12. Seat Adjustment

Ground Speed Lever Adjustment

Remove the ground speed lever mounting hardware

and bracket (see Figure 13). Move the levers to the

desired height using the adjustment holes. The bolts

need to be spaced so there is a hole open in between.

Reinstall the bracket and mounting hardware to the

levers.

Æ»»º ·Â·Ä¹¿Ä½ ºÀËÉÊÃ»ÄÊ

If the rider drifts to the right or left when the ground

speed levers are in the maximum forward position, the

top speed of each of these levers can be balanced. Only

adjust the speed of the wheel that is traveling faster.

Loosen the bolt securing the forward adjust plate (see

Figure 14). Slide the plate up approximately 1/8"

Retighten the bolt and recheck speed balance. Repeat

steps until adjustment is complete.

WARNING

DO NOT adjust the rider for a faster overall speed

forward or reverse than it was designed.