Safety And General Information; Product Description - Omega MagicLift 25048C Manuel Des Consignes D'utilisation Et Des Pièces

SAFETY and GENERAL INFORMATION

Save these instructions. For your safety, read, understand, and follow the information provided with and on this jack
before using. The owner and operator of this equipment shall have an understanding of this jack and safe operating
procedures before attempting to use. The owner and operator shall be aware that use and repair of this product
may require special skills and knowledge. Instructions and safety information shall be conveyed in the operator's
native language before use of this jack is authorized. If any doubt exists as to the safe and proper use of this jack,
remove from service immediately.
Inspect before each use. Do not use if broken, bent, cracked or damaged parts are noted. Any jack that appears
damaged in any way, or operates abnormally shall be removed from service immediately. If the jack has been or
suspected to have been subjected to a shock load (a load dropped suddenly, unexpectedly upon it), immediately
discontinue use until jack has been checked by a factory authorized service center (contact distributor or manufacturer
for list of authorized service centers). It is recommended that an annual inspection be done by qualified personnel.
Labels and Operator's Manuals are available from manufacturer.

PRODUCT DESCRIPTION

This Hydraulic Service Jack is designed to lift, but not support, one end of a vehicle. Immediately after lifting, loads
must be supported by a pair of appropriately rated jack stands. This MagicLift™ service jack has a unique feature
that provides fast, no load lifts to the jacking point, at which time it lifts in approximately 3/4" ~ 2" increments.
!
WARNING use hydraulic jack as stand-alone device. After lifting, immediately support the lifted vehicle with
a pair of appropriately rated jack stands.
SPECIFICATIONS
Model Capacity
25048C 4 Ton
25057 5 Ton
25107 10 Ton
Handle
Handle Position
Lock Lever (shown
unlocked)
Cover
Handle Sleeve
Plate
Foot Pedal
Figure 1 - Model 25048C Components
Jack Size (L x W x H)
50-5/8" X 15-1/2" X 7-1/2"
52-1/2" x 17-1/8" x 7-1/4"
55-7/8" x 19-5/8" x 9-5/8"
Release Valve
(handle knob)
Grease
Lifting Arm
Nipple
Vent Screw
(refer to parts breakdown
for location)
Swivel Caster
Min. Height
5"
6-1/2"
6-7/8"
Saddle
Front Wheel
Figure 2 - Model 25057 & 25107 Components
2
Max. Height
24"
22-1/4"
27"