MIRKA MIN6522511 Mode D'emploi page 9

Technical data
Model: MIN6522511
Input: 100–240 VAC, 50–60 Hz, 5 A, class I
Output: 22 VDC, 9 A
Idle power: < 2 W
General
To comply with the published safety standards, the following must be observed when using this switching power
supply
1 It is certified according to the relevant safety standards EN 61558-1, EN 61558-2-17 and EN 61558-2-6
2 This switching power supply incorporates a non-inherently short circuit proof safety isolating transformer
3 The output power taken from the supply must not exceed the rating given on the switching power supply
4 The appliance is not intended to be repaired by service personnel in case of failure or component defect (unit can
be thrown away)
5 The external flexible cable or AC cord of this switching power supply can be replaced If the cord is damaged, please
contact your local sales service directly
6 The power supply can be disconnected from the mains supply by pulling the plug or turning off the main switch
7 The socket outlet must be installed near the equipment and be easily accessible
8 For indoor use only
9 If the fuse blows, please turn off the power supply and disconnect from the mains supply, then contact your local
sales service directly
We reserve the right to make changes to this manual without prior notice
Disposal Information
DANGER!
Disposal information for the old appliance! Render redundant power tools unusable by removing
the power cord Only for EU countries Do not dispose of electric tools together with household
waste material! In observance of European Directives 2002/95/CE, 2002/96/EC and 2003/108/CE on
waste electrical and electronic equipment and its implementation in accordance with national law,
electric tools that have reached the end of their life must be collected separately and returned to an
environmentally compatible recycling facility
Manufacturer: KWH Mirka Ltd
Address: Pensalavägen 210, FI-66850 Jeppo, Finland
DC Power Supply • MIN6522511
en
9