MIRKA MIN6522511 Mode D'emploi page 30

en | us • ca
Introduction
Thanks for your purchase and use of MIN6522511 switching power supply, designed for electric tool application This
is a smart power supply, with output power limitation function controlled by software Please read and make sure you
understand the safety notes before use
Specification
Model no.: MIN6522511
Brand: Mirka
Input: 100–240 VAC, 50–60 Hz, 5 A, class I
Output: 22 VDC, 9 A
Features
Power factor: 0 98 @ 115 VAC, 0 92 @ 230 VAC
Idle power: < 2 W
Output power: 200 W (continuous), power limitation function
Efficiency: Typical 85% @ 115 VAC, typical 87% @ 230 VAC
Protection: Over temperature, overload, short-circuit
Ventilation: Ambient air
Aluminium enclosure
Agency listing
ETLus listed – Conforms to UL Standard 1012
cETL listed – Certified to CAN/CSA Standard C22 2 NO 107 1
Certified according to the relevant safety standards EN 61558-1, EN 61558-2-17 and EN 61558-2-6
FCC compliance statement
The switching power supply has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15:2009 and ANSI C63 4:2003, compliance with Industry Canada Interference-Causing Equipment Standard
ICES-003:2004 These limits are designed to provide reasonable protection against harmful interference in a residential
installation This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications However, there is no
guarantee that interference will not occur in a particular installation If this equipment causes harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• R eorient or relocate the receiving antenna.
• I ncrease the separation between the equipment and receiver.
• C onnect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• C onsult the dealer or an experienced radio/TV technician for help.
CAUTION
• T o reduce the risk of the electric shock, be sure the AC mains socket has an earth pin and is well grounded.
• D ry location use, for indoor use only.
• D o not expose the switching power supply to water, rain, or snow.
• T o reduce the risk of fire, use only on circuits provided with 16 ampere branch-circuit protection in accordance with
the National Electrical Code, ANSI/NFPA 70
Installation
Warning: Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/ NFPA 72/ANSI, and with
all local codes and authorities having jurisdiction Product is intended for indoor use only
30
DC Power Supply • MIN6522511