Controller Functions - Camp Chef Woodwind WiFi 20 Manuel D'instructions

Never Operate the Pellet grill without the ash cup in place.
Make sure the burner clean-out port is closed and locked
before starting the grill.
Never open the burner clean-out port when the grill is hot.
After cleaning out the burner make sure to close the burner
clean-out by pushing the clean-out port knob in on the left
side of the grill. Make sure to lift the pullout lock and push
the clean-out port knob all the way in and lock in place
with the pullout lock. Every 50 hours of use, remove the grill
grates, grease tray, and heat deflector and clean the inside
of the grill. If you notice a lot of ash blowing around in the
grill it is time to vacuum it out.
FILLING THE AUGER TUBE
CAUTION: ONLY USE THE FEED SETTING WHEN HOPPER HAS
RUN OUT OF PELLETS. FEED SETTING IS NOT FOR NORMAL
USE.
The first time you use your grill or any time the hopper has
run out of pellets you will need to fill the auger tube. This
simply means you must fill the auger tube with pellets until
pellets reach the burner. This is done by selecting FEED
from the main menu. This will turn the auger on and the
controller will display "FEED". The auger will remain on for
no more than 7 minutes. This is ample time for the pellets
to reach the burner. It is easiest to open the burner clean-
out by pulling the knob on the left side of the grill. Once you
hear pellets dropping into the cup you can close the clean-
out port by pushing the knob on the left side of the grill and
then select your cooking temperature. (Never operate grill
without the ash cup in place). Always make sure the burner
clean-out port is closed by pushing in the knob on the left
side of the grill before selecting any of the cook settings.
Never open the burner clean-out port when the grill is hot.
WARNING
APP QUICK START GUIDE
1. Download the Camp Chef APP from the Apple APP store or
Android Play Store.
2. Turn the Grill controller on using the main power switch.
3. Open the Camp Chef APP and follow the setup instructions
for connecting the grill to your home 2.4 GHz WiFi network.
WARNING - Do NOT leave this appliance unattended while
in use. The user must remain in the immediate area of the
product and have a clear view of the product at all times
during operation.
NOTE - Some functions are only available from the
controller. If attempting to start the grill from the APP it will
prompt you to confirm starting the grill from the controller.
Temperature and Smoke settings can be adjusted from the
APP. Shutdown can also be performed from the APP.
For more information visit https:/www.campchef.com/app
CONTROLLER EXPLANATION
POWER SWITCH
Used to turn the main power onto the pellet grill. "O" is Off.
"-" is On. See Fig. 13

CONTROLLER FUNCTIONS

Rotate the dial to scroll through menus, adjust temperature,
or smoke settings. Press the dial to select.
SHUTDOWN
This setting must be used after each use. Select SHUTDOWN
from the main menu. The fan will remain on for up to 20
minutes. This setting will burn up any extra pellets in the
burner and cool down the grill. Do not turn the main power
switch off when the grill is hot.
FEED - Select FEED from the main menu. This setting is
used to feed pellets to the burner. It will be used the first
time you use the grill to fill the auger tube and any time
you may inadvertently run the hopper out of pellets. See
instructions on filling the auger tube.
SET TEMP LOW SMOKE - Select SET TEMP from the main
FIG. 13