Bt Operations; Rds Operations - auna multimedia MD-140-BT Mode D'emploi

BT Operations

Pair with cell phone
First of all, move a cell phone close enough to the said product and then turn on the BT device in such cell phone.
Search the said product (code: 0000) for match-up.
Dial via BT
Once connected, press the Mode button to switch to "BTREADY" mode. press to call the last number or directly dial
via the numerical keypad on the remote-control (0~9) and then press to call.
Receive calls via BT
Once connected, when there is an incoming call, press on the front panel or on the remote-control to receive
such call. To change the call-receiving device, press and hold "2INT" on the front panel to switch among the cell phone
and the said product. When conversation is over, press on the front panel or on the remote-control.
Play back music via BT
Once connected, press the Mode button to switch to the Phone mode. Launch a kind of music playback software ins-
talled on the cell phone to play music. Under such circumstances, press and to select a previous or next track

RDS Operations

AF (Alternative Frequency) function
When the player is turned on for the first time, the system enters RDS (AF) state automatically. To
listen to other channels, please turn off RDS (AF) first, and then scan the channels, or else other
channels will be unavailable.
REG (Regionale Erkennung) function
In any state, press the SEL button to enter REG OFF state, and then use the VOL knob to select
REG ON or REG OFF.
TA (Traffic Announcement) function
In any state, press the SEL button to enter TA OFF state, and then use the VOL knob to select TA ON
and play the traffic broadcast automatically.
TA (Traffic Announcement) Volume selection
In any state, press the SEL button to enter TA VOL state, and then use the VOL knob to adjust the
TA volume.
EON (Enhanced Other Networks) function
In any state, press the SEL button to enter EON state, and then use the VOL knob to select whether
display the information of other channels.
PTY (Programme Type) function
In any state, press and hold the SEL button to enter part PTY state, and press the SEL button again
when the PTY type shows to enter the other PTY state. Then, use the number buttons (1~6) to select
the PTY type (note: each number buttons contains three types).
17
http://www.auna-multimedia.com
m u l t i m e d i a