Nice WMS01ST Instructions Et Avertissements Pour L'installation Et L'utilisation page 14

9
Season Season
Summer
Winter
Light
Light set
Light
Light set
Light
Light set
Light
Light set
Light
Light set
Light
Light set
Light
Light set
Light
Light set
8 - Parameters modifiable by the user
8.1 - Setting automatic command delivery to
pause
This function enables the user to temporarily suspend au -
to matic command operation. It is useful to prevent the
Summer
shut ter from moving autonomously during maintenance of
Winter
the automation, when cleaning the glass, watering plants
on the window ledge etc.
The function can be customised within the programming
environment by setting the "Manual pause" or "Timed pau -
se" option. For the latter it is also possible to set a desired
pause value (minimum 10 minutes). To activate or deacti-
vate the pause in the user screen, proceed as follows:
- Activate Pause:
(with display on) Hold the t key down until the
ual pause) or
display.
- Deactivate Pause:
• (with display on) If the display shows the
hold the t key down until the
• (with display on) If the display shows the
deactivation takes place automatically when the time
programmed by the installer expires. If the pause is to be
activated in advance, hold the t key down until the
symbol disappears from the display.
8.2 - Moving the position of the brightness cur-
sor-thresholds (fig. 10)
The user can move the brightness cursor-thresholds along
the "Light calibration" bar within the limits as set by the
installer, positioning it at the required brightness values.
Proceed as follows to move the cursor:
01. With the display on, briefly press t: the cursor starts
to flash.
02. To increase the level, press and hold p, or, to de -
crease press and hold q.
03. Then press ° to memorise the new position of the
cursor and return to the user screen.
If the regulation made does not have to be memorised,
wait for the display to switch off or press the ■ key.
(man-
(timed pause) symbol appears on the
symbol,
symbol disappears.
symbol,
8.3 -
Setting the temperature threshold
The user can set the temperature threshold value as re -
quired. To set this value, proceed as follows:
01. With the display on, briefly press u (a screen appears
with the values in centigrade of the set temperature
threshold).
02. To increase the level, press p repeatedly, or, to de -
crease pressq repeatedly.
03. Then press ° to memorise the new position of the
cursor and return to the user screen.
To exit without saving the settings entered, wait for the dis-
play to switch off or press ■.
10
English – 6