Monogram ZISP480DKSS Manuel D'utilisation page 13

Ice storage
bin
Important
facts about
your ice
& water
dispenser
49-60815 Rev. 1
To remove:
Lift up the access door to reach the icemaker.
Set the icemaker power switch to the OFF
position. With the access door closed, support
the storage bin at the bottom while slightly
lifting. Pull bin straight out.
To replace:
Slide the bin back until the tab on the bin locks
into the slot on the shelf. If the bin does not
go all the way back, remove it and rotate the
drive mechanism 1/4 turn. Then push the bin
back again.
• Do not add ice from trays or bags to the
storage bin. It may not crush or dispense
well.
• Avoid overfilling glass with ice and use of
narrow or extra-tall glasses. Backed-up ice
can jam the chute or cause the door in the
chute, push it through with a wooden spoon.
• Beverages and foods should not be quick-
chilled in the ice storage bin. Cans, bottles
or food packages in the storage bin may
cause the icemaker or auger to jam.
• To keep dispensed ice from missing the
glass, put the glass close to, but not
touching, the dispenser opening.
• Some crushed ice may be dispensed even
though you selected CUBES. This happens
occasionally when a few cubes accidentally
get directed to the crusher.
Ice & Water Dispenser (on some models)
Built-In Refrigerators
Ice Storage Bin
• After crushed ice is dispensed, some water
may drip from the chute as small particles of
ice melt.
• Sometimes a mound of ice chips will form
on the door in the ice chute. This condition
is normal and usually occurs when you have
dispensed crushed ice repeatedly. The ice
chips will eventually evaporate.
• Dispensed water is not ice cold. For colder
water, simply add crushed ice or cubes
before dispensing water.
• The first glass of water dispensed may be
warmer than the following ones. This is
normal.
• To eliminate drips on the spill shelf, tilt the
glass in slightly when dispensing water.
Access Door
Rotate
Drive
Mechanism
13