Toyotomi Zibro LC-400 Manuel D'utilisation page 25

P
TRANSPORTATION
Take the following measures to avoid fuel leakage during the transportation of
the heater:
1 Let the heater cool down.
2 Remove the removable tank
(refer to Section N, Fig. M). Some drops may leak from the filter; keep a cloth
at hand. Store the fuel filter and the removable tank outside the heater.
3 Place the transportation cap into the position of the fuel filter (Fig. N).
Press it tight. The transportation cap will, as much as possible, prevent oil
leakage from the heater during transport.
4 Always move the heater in an upright position.
5 Make the fixed tank empty with a fuel pump before transportation or in case
of wrong or dirty fuel. First remove the fuel filter and then insert the fuel
pump into the empty fixed tank. Follow the same procedure if the fuel tank
contains water.
Q
SPECIFICATIONS
Ignition
Fuel
Capacity (kW) max.
Capacity (kW) min.
Suitable space (m )
3 **
Fuel consumption (l/hr)
Fuel consumption (g/hr)
Burning time per tank (hr)
Capacity removable tank (litres) 7.6
Weight (kg)
Monitoring of the quality of ventilation (air renewal):
Direct measurement of the CO
* At maximum setting ** Specified values are indicative
from the heater and remove the fuel filter
electrical Dimensions (mm)
paraffin including base plate:
4.00
1.05 Accessories:
62-170
0.417 Mains
*
333 Electrical consumption:
*
18.2 - igniter
*
- continuous
11.5 Fuse rating
level (NDIR CO
2 2
width
depth
height
- manual fuel pump
- transportation cap
-- AC / 50 Hz
-sensor L).
Transportation
cap
435
315
437
230 V
320 W
24 W
250V, 5A
N
4
13