Ksenia porta KSI4300000.300 Guide D'installation Et De Programmation page 21

Once all settings are done, you can send the configuration to the porta gateway through Ethernet
cable.
Make sure that the gateway is powered on.
Ensure that the PC belongs to the same network as the gateway, otherwise change the address of
the PC, for example by setting:
ip = 192.168.2.91
subnet mask = 255.255.255.0
gateway = 192.168.2.1
To program the device:
1. Hold on the prog key:
• The PROG LED turns off
• It stays off around 10 sec.
2. Release the PROG key as soon as it turns on.
3. The PROG LED starts flashing slowly.
4. The status LEDs A and B flashes quickly in alternate mode.
5. The status LED ETH turns on (the device is in programming mode).
6. Press the "Download Configuration" key on software.
7. While programming, the red PROG LED
To exit from the programming mode just press shortly on the PROG key.
WARNING: The gateway has a factory pre-set with the following ip address: 192.168.2.92. It's possible to restore the factory KSENIA
Gateway conditions at any time by pressing and holding the programming button until it is completed this sequence on the red LED:
• The LED turns off during 10 sec.
• The LED flashes slowly
• The LED flashes quickly
• The LED stays lit
• Release the button
• Wait until the LED A and B flash quickly and alternately
• Remove power
At this point the porta is reset to its factory defaults.
GATEWAY PROGRAMMING
porta
If your computer
connected to the gateway, use a
crossover cable, otherwise use a
straight cable.
Make sure the gateway is powered
on.
To download the configuration
to the device use menu "Tools /
Program"
The recommended choice is to use
direct connection via crossover
cable.
is directly
21