Ksenia porta KSI4300000.300 Guide D'installation Et De Programmation page 18

Communication lares / porta:
Communication porta / KNX:
Actions followed by the gateway:
1. polling of the following informations on lares
- panel realtime
- partitions realtime
- zones realtime
- outputs realtime
2. listening / sniffing data on KNX BUS
Output gateway port: UDP port from which porta sends UDP data to lares
Input gateway port: UDP port from which porta receives UDP data from lares
Output lares port: UDP port from which lares sends data
Input lares port: UDP port on which lares receives User PIN data: the user PIN used by porta Gateway
while performs actions towards the panel. This PIN has to be previously programmed and enabled
on panel.
Konnex physical address: KNX address assigned to the gateway. This address cannot be assigned to
another KNX peripheral nor be notified on KNX project in any case. Just pay attention to install porta
on the main blackbone and be sure that the device can receive all datagrams with which interact.
Gateway net settings: the porta needs these settings in order to communicate with the panel. This
addres has to be univocal.
Please note as lares doesn't recognize porta nor di KNX world and vice versa. When the gateway
performs actions towards lares, it's considerated simply as an user that use web server or basis.
In the same way, when the gateway performs operations on KNX system it's considerated as a KNX
peripheral.
NOTE
The Konnex Scenarios that the gateway porta can perform on lares Control Panels are reported in
"Group Addresses for Command" sections.
The Konnex Scenarios that the lares Control Panels can perfom on porta Gateway are reported in
"Group Addresses for Status" sections.
18
PANEL
Ksenia UDP protocol
KNX Protocol
porta