PROUSER AC150A Mode D'emploi page 6

B. To operate compressor using the Preset Automatic shut off feature:
1. The gauge will display the current tire pressure in the right area of display in big letters.
2. The gauge is pre-set at the factory to "0.0". Press the "+" or "-" to change the shut off pressure
setting to the desired automatic shut off pressure (Maximun:150PSI)
3. Push the power button (2) to start working. The air compressor will automatically shut off when it
reaches the preset pressure setting.It means the number in the left area will be equal to the
number in the right area.
CAUTION:
- Do Not Over Inflate! To avoid overinflation of tires please check the recommended car
tire pressure in the vehicle's owner manual. For bycicle tires please check the tire
marking.
- We recommend to inflate 2 PSI more then recommend as the quick connector valve
leaks around 2 PSI when disconnectiong from the tire.
INFLATING SPORTING EQUIPMENT OR PARTY BALLOONS
1. Open the side cover (10), roll out the 12V cord and connect the 12V plug (9) to the vehicle's outlet
2. Insert ball/balloon adaptors (included in cabinet 7) into the quick connector and push down the
valve lock lever to secure the connection. Turn on vehicle's engine. The compressor is now ready
to use.
3. Insert the ball/balloon adaptor into the valve of the object to be inflated.
4. Press the Pressure buttons (1) to change the shut-off pressure to "0.0". The gauge is pre-set to
"0.0"at the factory , it means that the compressor will work in the mode without preset function if
no pre-setting.
5. The gauge will display the current tire pressure in the right area of display in big letters
6. Push the power button (2), the compressor will begin to operate. Inflate your tire the correct
pressure and shut off the compressor by pushing the power button (2) again.
7. Remove quick connector from the tire and disconnect the 12V plug and store the adapter back to
the cabinet (7)
CHANGING PRESSURE FORMAT
The Digital Tire Pressure Gauge is capable of reading air pressure in the following formats: PSI and
BAR.The North American standard format is PSI and the gauge is preset/defaulted at the factory in the
PSI mode.If you desire to change output mode from PSI to BAR do the following:
1. Connect the 12 Volt plug (9) into cigarette lighter outlet,to power the air compressor.
2. You can press the unit button (3) to select the desired pressure unit
3. After selecting the mode,the gauge will read the output mode in small letters at the top of the LCD
Display,(PSI or BAR)
6