PROUSER AC150A Mode D'emploi page 5

OPERATION
The compressor is equipped with a Digital Tire Pressure Gauge. The digital Gauge can be used to
monitor air pressure when inflating your desired object and can automatically shut off the Compressor
once pre-set desired pressure is resached.
INFLATING TIRES
1. Open the side cover (10), roll out the 12V cord and connect the 12V plug (9) to the vehicle's outlet.
2. Connect quick connector (8) onto tire's valve stem and push down the valve lock lever to secure
the connection. Turn on vehicle's engine. The compressor is now ready to use.
A. To operate compressor without pre-set function
The left side of the display panel (please see below) indicates the pre-set pressure gauge. When the
pre-set gauge is at "0.0", it means that the compressor will work without the pre-set function.
1. Press the Pressure buttons (1) to change the shut-off pressure to "0.0". The gauge is pre-set to
"0.0"at the factory , it means that the compressor will work in the mode without preset function if
no pre-setting.
2. The gauge will display the current tire pressure in the right area of display in big letters
3. Push the power button (2), the compressor will begin to operate. Inflate your tire the correct
pressure and shut off the compressor by pushing the power button (2) again.
4. Remove quick connector from the tire and disconnect the 12V plug.
CAUTION:
- Do Not Over Inflate! To avoid overinflation of tires please check the recommended car
tire pressure in the vehicle's owner manual. For bycicle tires please check the tire
marking.
- We recommend to inflate 2 PSI more then recommend as the quick connector valve
leaks around 2 PSI when disconnectiong from the tire.
5