Oster 078006 Mode D'emploi page 7

MAINTENANCE
To clean the blades, plug clipper into electrical outlet
and turn on. In a shallow pan, immerse blade teeth into
Oster™ Blade Wash™ cleaning solution.
Caution: DO NOT IMMERSE THE CLIPPER.
Remove blade from cleaning solution and while holding
clipper blade end down, wipe the blades with a dry, clean
cloth.
If after cleaning, you find that the blades still do not cut
properly, it is possible that a few fine pieces of hair are still
trapped between the blades.
If this occurs, remove the blade. Without loosening the
tension springs screws, slide the upper blade to one side
but not completely out from under the tension spring.
Wipe the surface between the blades clean with a dry cloth.
Place a drop of oil on the mating surfaces and in the tension
spring guide slot. Slide upper blade to the other side and
u
repeat process . Slide the upper blade back into position
and reassemble the clipper. With the clipper running, lubricate
the blades with a light coat of Oster™ Kool-Lube™ lubricant
or a drop or two of Oster™ Premium Lubricating Oil.
Sharpening
Oster™ cutting blades are of individual hollow-ground design, hardened to extend cutting
life. As with any cutting tool, the cutting edges will become dull after extensive use. If
sharpening is necessary, send blades to an Oster™ Authorized Service Center.
Storing Your Clipper
Store your clipper in a clean, dry space. Be careful not to tangle the cord while storing
the clipper. Do not wrap cord around the clipper when storing. This can damage the
cord insulation.
- English-7 -