Fujitsu D2151 Serie Description De Produit / Manuel D'installation page 17

Procedure
The processor socket ist covered with a protective cap to protect the spring
contacts In the event of a warranty claim, the mainboard can only be taken back
by Fujitsu Technology Solutions with the protective cap attached!
b
Please note that, depending on the heat sink used, different heat sink
mounts are required on the mainboard.
► Depending on the configuration variant, you must pull a protective foil off the heat sink
or coat the heat sink with heat conducting paste before fitting it.
► Secure the heat sink - depending on the model - with four screws or push it into the mounts.
A26361-D2151-Z212-1-8N19, edition 1
b
a
Brief description of the mainboard
► Remove the heat sink.
► Press down the lever and unhook it.
► Lift up the frame.
► Hold the processor between your thumb
and index finger and insert it into the socket
(b) so that the marking of the processor is
aligned with the marking on the socket (a).
► Press the lever downward until it
engages again.
► Remove the protective cap and keep it.
English - 3