Ordering Replacement Parts - ALPHA-TOOLS SS 135 Instructions De Service

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Anleitung SS 135_SPK7

29.06.2006

Please read the operating instructions carefully

before assembling and using.

Safety information

Please refer to the booklet included in delivery for the

safety instructions.

Application

The orbital sander is designed for sanding/grinding

wood, metals, plastics and similar materials using the

appropriate sanding/grinding paper.

Layout (Fig. 1)

1 Front handle

2 ON/OFF switch

3 Locking knob

4 Handle

5 Extractor connection

6 Sanding/grinding plate

7 Clamping device

Attaching the dust extraction connector

Important!

For health safety reasons it is imperative that you use

a dust extraction device.

ON/OFF switch (Fig. 3)

To switch on:

Press switch 2

Continuous operation: Secure switch 2 with locking

knob 3

To switch off:

Briefly hold down switch 2

Fastening the sanding/grinding paper (Fig. 4)

Pull out the power plug first.

Insert the sanding/grinding paper into the open

clamp and close the clamp.

Lay the sanding/paper over the oscillating plate

so that the paper is taut and clamp it again.

Make sure that the perforations in the

sanding/grinding paper coincide with the

oscillating plate.

14:40 Uhr

Seite 5

Technical data

Voltage

Power input

Sanding/grinding surface in mm

Size of sanding/grinding paper in mm

Vibrations per minute

Vibration a w :

LWA sound power level

LPA sound pressure level

Weight

Totally insulated

Cleaning, maintenance and ordering of spare

parts

Always pull out the mains power plug before star-

ting any cleaning work.

Cleaning

Keep all safety devices, air vents and the motor

housing free of dirt and dust as far as possible.

(Fig. 2)

Wipe the equipment with a clean cloth or blow it

with compressed air at low pressure.

We recommend that you clean the tool immedia

tely after you use it.

Clean the equipment regularly with a moist cloth

and some soft soap. Do not use cleaning agents

or solvents; these may be aggressive to the tool's

plastic parts.

Ensure that no water can get into the interior of

the tool.

Carbon brushes

In case of excessive sparking, have the carbon

brushes checked only by a qualified electrician.

Important! The carbon brushes should not be

replaced by anyone but a qualified electrician.

Maintenance

There are no parts inside the equipment which

require additional maintenance.