Atlantic WALL SPOUTS WSM-S Manuel Du Produit page 3

All fittings and pipe stubs should be dry fit
before final installation. It is recommended
to fully tighten a 1 ½" male thread adaptor
(MTA) to the spout, then glue the MTA to
the horizontal feed line while holding the
spout level. This will ensure the threads on
the MTA are properly oriented. Small
adjustments can be made to level the
spout after the glue sets.
When plumbing multiple spouts using one
pump, run a main feed line along the back of
the wall, teeing up to the individual spouts
(see Figure 4). If plumbing multiple spouts at
the same height, individual ball valves are not
needed. If the spouts vary in height, it is best to
install a ball valve in each line feeding the spouts to provide more control over the
flow. When running more than three spouts, the main feed line should be increased
to at least 2".
Figure 4
Maintenance:
Depending on water conditions, Wall Spouts may require periodically cleaning. Turn the
pump off and remove any large obstructions that may be present. Wipe down the interior
of the spout with a non-abrasive cloth. A mild cleaning solution intended to remove
calcium and lime can be used if deposits from hard water are present.
Warranty:
Wall Spouts carry a three-year limited warranty. This limited warranty is extended solely to
the original purchaser commencing from the date of the original purchase receipt and is
void if any of the following apply:
• The Wall Spout has been misused or abused.
• The Wall Spout has been disassembled or modified other than as described in this manual.
This warranty excludes labor/costs of labor for removal or installation of any product.
Figure 3
1½" PVC
2" feed line
3