Set-Up - Renkforce CD-2000ME Notice D'emploi

10. Set-Up

When selecting the set-up location, please take into consideration the room layout such as the where-
abouts of the nearest socket, etc.
When selecting the set-up site, observe that direct sunlight, vibration, dust, heat, cold and moisture must
be avoided. There also must not be any strong transformers in the device's proximity.
Only operate the device on a stable, horizontal surface. There must be enough air circulation to
permit dissipation of the generated heat. Therefore, only place the device on a level surface and
not on carpets, etc. Do not cover up the ventilation slots in the casing.
Non-observance of this note may cause damage to the device.
Do not drill or screw any additional screws into the casing to mount the device. This damages the
device and it may become possible to touch potentially fatal mains voltage.
Only operate the CD player in a horizontal position, otherwise it will not function properly. If this
note is not observed, the inserted CD or the CD player may be damaged.
Make sure you position the device safely. Falling devices may pose a significant risk of acci-
dent.
Place the mains cable and all other connected cables where no one can trip over it.
Due to the diversity of surfaces and furniture paints and polishes used, it is possible that the
device's feet will leave visible residue on furniture due to chemical reaction. Pressure spots may
be caused by the weight as well.
The device therefore should not be placed on valuable furniture surfaces without any suitable
protection.
33