ABAC XPN O15 Manuel D'utilisation Et D'entretien page 13

ADJUSTING THE WORKING PRESSURE
2.5
This compressor is equipped with an adjustment valve
for maximum working pressure: 8bar.
There is no adjustment or variation device for use
pressure.
d
c
K
I C
C L
2
2
1
16
1
?
17 18
STOP
230 V.
?
STOP
120 V.
2. INSTALLATION UND GEBRAUCH 2. INSTALLAZIONE ED USO 2. INSTALLATION AND USE 2. INSTALLATION AND USE
CAUTIONS WHILE USING
2.6
Do not perform operations on the compressor unless
you have disconnected the power plug.
Temperature in operating ambient: 5°C +35°C.
Do not aim jets of water or inflammable liquids on the
compressor.
Do not place inflammable objects near the compressor.
During stays, bring the start switch to position "0"
(OFF).
Never aim the air jet at people or animals.
Keep children and animals well away from the machine
operating area.
If using the compressor for painting:
a) Do not work in closed environments or near naked
flames
b) Make sure there is adequate exchange of air
c) Protect your nose and mouth with an appropriate
mask.
If the electrical cord or plug are damaged, do not use
the compressor. Contact an authorised service centre
to replace the faulty element with an original spare
part.
Do not insert hands and/or any object inside
protection grilles.
When you have finished use, always remove the plug
from the power socket.
Step 1
OFF
Step 1
OFF
Step 2 Step 3 ON
Step 2 Step 3 RESET
Step 4 ON
EN
21