Adjustment - EDM 08757 Manuel D'instructions

Grass Trimmer

Adjustment

Adjusting Product Length / Loosen the adjustment
collar.
Pull the shaft out to increase the height, or push the shaft in
to decrease the height. Re-tighten adjustment collar.
Switching On and Off
Press lock off firstly, then press switch button to start work.
Release switch for switching off.
Cutting Grass
Move the trimmer left and right, keeping it well away from
the body.
Cut taller grass in stages.
Remove the wheels when cutting long grass
Cutting Around Trees and Bushes
Using with Auxiliary wheels when cutting around trees and
bushes, in this way, they do not come into contact with the
cutting line.
Instructions for use
CAUTION!
Do not employ the device without the correct safety guard.
Make sure it is functional before every use.
Hold front handle with one hand and auxiliary handle with
the other hand.
Make sure that cutting line is fed out before operation.
Do not switch the machine on with the cutting head on or
near material to be cut. Ensure the machine is at full speed
before contacting material to be cut.
Keep unit below waist level.
Work only from your right to your left to ensure debris is
thrown away from you. Proceed slowly, keeping the
trimmer inclined (approx. 30°)
Without bending over, keep cutting head near and parallel
to the ground (perpendicular when edging). Allow only the
tip of cutting line to make contact.
Do not cut damp or wet grass.
High grass should be cut in layers, always beginning from
the top. The cuts should be short.
Avoid wearing the cutting line out quickly by knocking
against hard objects (stone, walls, fences etc).
EN INSTRUCTION MANUAL
To edge, rotate the upper shaft with front handle 180°, place
the edger wheel and cutting head above the surface you are
going to edge.
Replacing the trimmer spool
WARNING!
Use only cutting lines with correct diameter. Other sizes of
cutting line will not feed properly and will result in improper
function or can cause serious injury.
Fitting trimmer spool and cutting line complete
Your trimmer is supplied with a fully disposable trimmer
spool which overcomes troublesome rewinding the cutting
line
1. Remove the battery pack.
2. Clean any grass or debris from the trimmer head.
3. Press and hold in the cover release latches to open the
cutting head cover and pull out the old trimmer spool from
the cutting head.
4. Clean out the cutting head.
5. Insert the end of the new cutting line through the spool
eyelets and put the new trimmer spool into the cutting
head.
6. Refit the cutting head cover.
7. Pull out the end of the cutting line until they reach the
outside edge of trimmer safety guard.
REF. 08757