Jensen DUB 11000D Manuel D'installation page 7

G round T erm inal ( G N D )
Make the ground lead as short as possible, lea ving enough length to complete
the installation and to allow for any service that may be needed at a later date.
To ensure a good ground, scrape away any paint or undercoating to expose
bare metal. Use a "ring" terminal of the proper gauge and an "outside star
washer" (bet ween the chass is and ring terminal) when making your ground
connec tion. Although you've scraped away the paint to expose bare metal, the
outside star washer will help to "bite into" the chassis for a tight, secure
ground.
Drill hole in chassis sheet metal.
R ep l acem ent F us e R eq uirem ents ( F U SE )
M odel Q uantity Amps
11000D 3
35
POWER INPUT
+12V REM GND
Type
ATO
E nd C ap I ns tal l ation
ter the a li ier is o nted to the vehicle asse ble the end ca s ro above
see diagra hile holding the endca in lace insert and tighten the two
screws o not over tighten
a li ier and a be re oved i o do not want to se the end ca s
ca s a be ainted to c sto
5
DUB Edition Amplifiers
he end ca brac ets are reinstalled on the
atch to o r vehicle
he end