Testing; Remote Input Level Control - Jensen DUB 11000D Manuel D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Testing

Be ore inishing the installation erform the follow ing tests to make sure the
wiring is correct and everything is operating properly.
Reconnect Battery
When wiring is complete, reconnect the battery negative terminal.
Test Power Wiring
rn on the receiver b t do not t rn
sho ld co e on
not chec the
vol
e slightl
ll s ea ers sho ld o erate
a
li ier and s ea ers
Test Speaker Connections
These tests make sure the speakers are connected properly. If speakers don't
play at all, one (or both) speaker wires may be disconnected.
the vol
e he a
li ier ower light
and 12V B
wires
rn
the receiver
not chec wiring connections at

Remote Input Level Control

The
Ba11
comes equipped with a Remote Input Level Control. The
Remote Input Level Control allows the input level to be adjusted from an
alternate location. It can be mounted under-dash or in-dash. When the
a
li ier is sed to drive s bwoo ers and the low ass crossover is activated
the e ote n
t Level ontrol can be sed as a re ote bass level control
This enables you to control the bass level independent from the rest of the
system. This is convenient for system tuning and/or when playing many
di erent t es o
sic
The Remote Input Level Control uses a 3.5mm modular cable for connectivity.
i
l
l g the
od lar cable into the a
e ote n
t Level ontrol to activate the circ it
REMOTE
CONTROL
GAIN
Min
Max
9
DUB Edition Amplifiers
li ier and then into the

Publicité

Table des Matières
loading

Table des Matières