Using The Tap; Operation; Child Safety Lock - clage Zip HydroTap G4 B 160 Instructions D'utilisation Et D'installation

Zip HydroTap ® G4 B160

5. Using the Tap

Boiling water lever
Note: If the drinking water system has not been used for several days, allow the
tap to run water for about five minutes.
EN

Operation

Press the red lever to dispense boiling water. Pull the lever up to dispense boiling
water continually. The water will flow for 5 to 15 seconds. This time can be set in the
menu. The lever then has to be manually returned to the Off position.
Red light
• On all the time: boiling water is ready and can be dispensed.
• Flashing: the water has not yet been heated to the set temperature.
White filter LED
• Flashing: the filter needs to be replaced. This LED starts flashing according to filter
use and the filter capacity set in the menu.
White filter LED

Child safety lock

A child safety lock can be enabled to prevent boiling water flowing out of the tap if the
red lever is accidentally operated. To dispense boiling water when the child safety lock
is enabled, press the Safety button and the red lever at the same time.
The child safety lock can be enabled and disabled under Settings/Safety in the menu.
Menu
The undersink unit has a touch screen which can be used to set and read the operating
parameters. The following settings can be carried out in the menu:
'Language'
Select the language used in the menu.
'Information'
Shows data specific to the unit and any errors occurring.
'Install'
The steps that are necessary when using the unit for the first time can be viewed again
for maintenance purposes.
Safety button Flush filter – place the end of the hose located at the filter in a collecting container and
open the isolating valve on the hose before starting to flush the filter.
Reset filter – resets the filter consumption data.
Boiling point calibration – the unit determines the boiling point, which depends on the
atmospheric pressure at the installation location, and adjusts accordingly.
Booster – settings for operation of an additional instantaneous water heater to
preheat the hot water. A technical modification has to be made to the unit in order to
connect up a booster (not included in CLAGE range).
Light sensor calibration – the light sensor on the tap can be calibrated for the light
conditions at the installation location. This is necessary to ensure that the Sleep mode
energy-saving function operates correctly. Shield the tap from direct sunlight during
calibration.
'Service'
A special password specific to the unit is needed in order to access the Service menu.
Please contact Central Customer Service.
'Password'
A user password can optionally be set to lock the 'Settings' menu and prevent
unauthorised persons from altering the settings. The password should be 4 digits long.
20