EN
Commissioning
Prerequisites
Commissioning the Geberit sanitary flush
and malfunction diagnosis are completed
using a smartphone and the Geberit
SetApp. The Geberit SetApp is available free
of charge for Android and iOS smartphones
in the respective app stores (see QR code).
The app communicates via a Bluetooth
interface with the Geberit sanitary flush.
Commissioning with the
Geberit SetApp
Until the product is commissioned, the red
LED on the control unit of the Geberit
sanitary flush flashes.
1
Install the Geberit SetApp on your
smartphone. To install the app, scan
the QR code or visit app.geberit.com/
setapp.
2
Start the Geberit SetApp and
perform the following steps for
commissioning.
3
Establish a connection with the
Geberit sanitary flush.
4
Call up the <Basic settings> menu.
Check the settings and make any
necessary changes.
5
Call up the <Flush settings> menu.
Program the flushing parameters.
12
If the Geberit sanitary flush is
linked to the building service
management system via RS485
or digital I/O, it is not necessary to
program the flushing parameters.
The sanitary flush will be fully
controlled by the building service
management system.
Factory settings
If no flushing parameters are programmed,
the Geberit sanitary flush will function using
the following factory settings.
Table 1:
Factory settings
Parameter
Description
Flush
Time between two
interval
flushes
Flush time
Duration of each
flush
However, we recommend that the flushing
parameters always be programmed.
Display of operating status
The control unit of the Geberit sanitary flush
displays the following operating statuses:
Table 2:
Operating statuses
Element Status
Green
Short flash
LED
pulse
Long flash
pulse
On
Off
Red LED On
Flashing
Off
Value
48 h
180 s
Meaning
Normal operation,
operating voltage
on
Normal operation,
Bluetooth
interface active
Solenoid valve
open
Operating voltage
off
Malfunction,
diagnose with
Geberit SetApp
Warning, diagnose
with Geberit
SetApp
Normal operation
B1208-001 © 10-2014
966.716.00.0 (00)