Transistor Lynx Door Transmitter Manuel page 4

ENGLISH
Connecting alongside the existing
doorbell
The door transmitter can either be fastened using
double-sided adhesive tape or screwed on. Screw
on the door transmitter from the front using the
through screws. Remove the plug for the upper
screw hole. NOTE: two screws on the rear must
be removed before the door transmitter can be
screwed on.
Connecting to the existing doorbell
The existing doorbell will ring and the receiver in
the Lynx system will send out an alert.
1. Unscrew the door transmitter.
2. Connect the two cables which are attached in
the existing doorbell to the connecting strip in
the door transmitter.
NOTE: This connection requires a transformer which
complies with standard EN 60558-1/60558-2-6
and is fused on the door transmitter side with a 2A
fuse (see figure 2a).
2a.
2A fuse
230V IN
Max 24V OUT
Transformer
Connection to mains-connected doorbell
4
Mains-
connected
doorbell
Door transmitter
1.
2b.
Battery-
powered
doorbell
Door
transmitter
Connection to battery-
powered doorbell