Startup / Operation - Proficook PC-WK1235 Mode D'emploi

Electrical connection
WARNING:
 The installation to the mains supply must conform
to the local standards and regulations.
 Improper connection may cause to an electric
shock!
 Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
 The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
 Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
 Connect the mains cable to a properly installed
and earthed wall outlet.
 If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.

Startup / Operation

Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for approx. four hours before connecting to
the power supply. Nonobservance could lead to mal-
function of the cooling system and causes an appli-
ance breakdown.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
"Cleaning and Maintenance"
the chapter
Starting the appliance
 Connect the appliance to the power supply.
 Set the desired indoor temperature. Read the
following sections.
Operation overview
1
2
3
4
5
 Press the button (1) to switch the interior lighting
off and on again.
 By pressing the button (2), you can change the
temperature display to Fahrenheit or Celsius.
 Use the buttons (4) and (5) to set the interior tem-
perature. The display (3) shows the selection.
A few seconds after the last button press, the
temperature display will automatically change to
the actual temperature value currently in the ap-
pliance.
Settings
The temperature value is adjustable between:
+4°C to +18°C (+39°F to +65°F)
The reachable value cannot be higher than the am-
bient temperature at the place of installation.
An operating temperature of approx. +12°C is rec-
ommended.
During initial startup, longer standstill of the device or
temperature adjustment, there may be a deviation of
a few degrees between the temperature you have
selected and the temperature shown on the display.
.
It takes some time until the desired temperature has
been set.
Basically, the temperature changes depending on the
ambient temperature (place of installation), the fre-
quency of opening the door and the equipment.
35
Switch interior lighting on and off
Switch display between °C and °F
Display
Increase temperature stepwise by 1°C (1°F)
Decrease temperature stepwise by 1°C (1°F)