Declaration Of Conformity - AVS Electronics XSAT WS 4 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operation
Depending on the type of controller with which it is combined, XSAT WS 4 can manage:
up to a maximum of 32 wireless sensors
up to 64 remote controls
n°1 wireless siren
The various wireless accessories are acquired and programmed through a keyboard or dedicated software.
Each system supports only one wireless siren of the WS 4 series.
To activate and deactivate the siren in alarm, the relay output relative to the satellite in which it is store must be programmed in the controller.
The optical signals from the flash of the siren and the BIP 4 Plus can be activated by suitably programming the OC outputs 2, 3 and 4 of
the satellite in which it was stored:
The flash of the siren does a "controller on" flash when the OC is activated and a "controller
O.C. 2
off" flash when it is deactivated. BIP 4 Plus: when o.c. is activated the red LED lights up and the buzzer will sound and when the o.c.
is deactivated the green LED and the buzzer sounds two short beeps.
The flash of the siren does a "controller on" flash when the OC is activated and none when
O.C. 3
it is deactivated. BIP 4 Plus: when o.c. is activated the red LED lights up and the buzzer will sound and when the o.c. is deactivated
nothing happen.
The flash does a "controller on" when the OC is activated and none when it is deactivated. BIP 4 Plus: when the o.c. is activated the
O.C. 4
green LED lights up and the buzzer sounds two beeps and when the o.c. is deactivateed nothing happen.
For programming the wireless siren of some of the more advanced controller models, refer only to what is shown in the controller manual.
The product covered by this declaration complies with the essential requirements of Directive 1999/5 / EC (R&TTE) on the equipment and use low
power radio transmitters frequency spectrum, in accordance with the CEPT 70-03 Recommendation.

Declaration of conformity

AVS Electronics S.p.A. declares that XSAT WS 4 complies with the essential requirements and other relevant regulations laid
down in Directive 2004/108 / EC and complies with the European Standard EN50131.
The declaration of conformity may be consulted using link: http://www.avselectronics.com/en/download-software-and-tech-
nical-manual or by using this QR CODE
Brand
Model
Operating frequency
Type of power
Rated voltage
Rated Current
European Community countries where it is intended for use
Date
L'AVS ELECTRONICS S.p.a. reserves the right to make changes at any time without advance notice.
Information in accordance with Directive 1999/5 / cee (r & tte)
AVS ELECTRONICS
XSAT WS 4
868 MHz
Direct Current
13,8 V =
30 mA at rest
45 mA Receiving
70 mA Transmission
No restrictions in the EU countries
06/07/2015
- 8 -

Publicité

Table des Matières
loading

Table des Matières