Selecting A Mode - REEF ONE biOrb HALO 15 Mode D'emploi

Multi-Coloured Remote Lighting
The 15L biOrb Halo has 6 Multicoloured
LED's fitted into the top of the aquarium
controlled by a remote handset ( ). If the
lights are not coming on when you press
the ON button check the inline power
switch (B) is in the ON position and you
have the remote control pointed directly
at the front of the aquarium
with no obstructions (C).

selecting a mode

The lights switch on in WHITE mode.
There are 16 further colour modes which
can be selected using the remote control.
If you want to set your own special colour,
you can press the COLOUR MODE
BUTTON which will scroll the lights
through all colours until you stop it by
pressing the SETTINg BUTTON
Dimming the lights
All colours start at 100% intensity. If you
find the lights too bright you can dim
them down in 20% reductions (from 80%
to 20%) using the BRIgHTNESS
BUTTONS on the right of the remote.
If you want to return to full intensity
press any other button to reset.
a
16
prE-sEt
rgb
ON OFF
colours
R G
b
c
sEtting
button
colour moDE
button
B W
brightnEss
buttons
troubleshooting
Q. When I press the on button there
are no lights on the aquarium?
A. Check the inline power button is in
the ON position. If the lights still don't
respond, make sure the remote is pointing
directly at the front of the aquarium.
Finally, check the battery in the remote.
Q. I have to stand very close to the
aquarium for the remote to work?
A. The battery of the handset probably
needs replacing with new CR2025 as
soon as possible.
Q. Is the remote handset waterproof?
A. No, the handset must not be sub-
merged in water and if it fails to work after
contact with water you will need to
purchase a replacement.
Q. When I open the lid there is water
dripping down the outside of the tank.
A. Ensure you have the evaporation tray
correctly installed and the feed hole plug
in place. With a soft cloth, gently wipe
away any remaining water.
Q. I don't like the colour I've selected, how
can I change it or return to white light?
A. If you are not happy with your colour
W
choice you can press the button or
the OFF then the ON button to return to
100% white light.
L