Generator Ac Connection System; Grounding The Generator; Utility Circuit Connection - Rheem GEN12AD-V Manuel D'installation

Generator AC Connection System

A single-phase, three-wire AC connection system is used
in the generator. The stator assembly consists of a pair
of stationary windings with two leads brought out of each
winding. The junction of leads 22 and 33 forms the neutral
lead, as shown schematically and as wiring diagram.
A complete schematic and wiring diagram can be found later
in this manual.
NOTICE Neutral is not bonded to ground at generator.
33
22
Circuit
Breaker
11
44
0 22
Ground Neutral
To Transfer Switch
Neutral
120V
120V
240V
44 44 44 11 11 11
Ci Circui Ci Circuit i
Break Breaker
Line 2 Line 1
The conduit (A) between the corner electrical inlet and the
control panel is a UL requirement. If removed, it must be
replaced with similar conduit.

Grounding the Generator

Ground the generator per applicable codes, standards, and
regulations. The generator GND lug is located inside the
control panel door under the circuit breaker cover.

Utility Circuit Connection

ion on
board, optional battery warmer and optional oil warmer. This attery warme attery warm
power also charges the battery. When power on these leads arges the bat arges the b
is lost, the generator will start. generator wi generator w
Using provided 2 pin connector plug and installer-supplied rovided 2 pin ovided 2 p
minimum 300V, 14 AWG wire, connect each control circuit mum 300V, mum 300V,
terminal in the generator to the two-amp fuse terminals in rminal in th rminal in the
the automa the automatic transfer switch. he autom
When making connections, obey wire type and torque When m When m
spec spe specifications printed on the circuit breaker and neutral/
g g ground connector.
A
23