Access Ports - Rheem GEN12AD-V Manuel D'installation

Access Ports

Each generator is shipped with a set of identical keys. These
keys fit the locks that secure the access ports.
To open access door:
1. Insert key into lock of access door and turn key one
quarter turn counterclockwise.
2. Remove key.
To close access door:
1. Close control panel door and insert key into lock and
turn key one quarter turn clockwise.
2. Remove key.
The generator is equipped with a removable roof and
removable side panels to permit simple servicing.
To remove roof and divider:
1. Open the control panel access door.
2. Set generator's circuit breaker to OFF position.
3. Set control panel system switch to OFF.
4. Remove 15 Amp fuse from control panel.
5. Move roof latch (A) to the left until roof pops up slightly.
A
6. Lift roof off generator.
7. Rotate 4 knobs 1/4 turn and lift divider off.
8. Replace divider and roof in reverse order.
18
To remove side panels:
1. Open the control panel access door.
2. Set generator's circuit breaker to OFF position.
3. Set control panel system switch to OFF.
4. Remove 15 Amp fuse from control panel.
5. Remove roof and divider.
6. Lift latches (B) up on both sides of panel to release.
7. Pull panel upward and out of grooves.
To remove exhaust panel: haust panel: haust pane
1. Remove roof and divider. ove roof and ve roof and
2. Remove side panels. emove side move side
WARNIN WARNIN WARNING Contact with muffler area could cause burns
resulting in serious injury. re
DO NOT touch hot parts and AVOID hot exhaust gases.
Allow equipment to cool before touching.
3. Remove 6 screws (C) from exhaust panel.
C
C
C
B
C
C
C