Zagg Nomad Book Instructions page 3

INSTALLING THE 10.5-INCH IPAD PRO
If you have a 10.5-inch iPad Pro, the correct bumper and button strip have already been
installed. The last part of the installation is listed below.
1. A magnet has already been installed in the Nomad case. Pull off the protective lining
from the sticky side of the magnet.
2. Set the bottom of your tablet into the groove at the bottom of the case, and then
press the rest of your tablet into place. It should fit snugly against the bumper at the
top of the case.
3. Press against the back of the case to ensure the adhesive side of the magnet
attaches to your tablet.
Removing the
Adhesive Liner
Attaching Your Tablet to the
Magnet
2