Group Selection - Albrecht TelMe-11T Guide D'utilisation

For TelMe-E Headset receiver press and hold the "Power" button
longer than 2 seconds. The "Operating Status LED in Blue" is
blinking every 2 sec.
Press and hold the "Power" button longer than 2 seconds again
to turn the device's power off. The "Operating Status LED" in
Red is blinking 5 times rapidly and off.
3.2. Transmission (TelMe-T only)
The transmission is starting automatically as soon as the device
is turned on. The LCD is displaying "TALK"
3.3. Reception (TelMe-R only)
The unit starts receiving automatically after switching it on. The
signal level bar is changing according to the strength of the
received signal.
For the TelMe-E Headset receiver please refer to 3.4 Group
selection and set the Group selection first. If you didn't set the
Group selection in previous or if you want to change the Group
selection from the last time using. The "Operation status LED in
Blue" is blinking twice in 5 seconds once the group number is
matched between TelMe-T and TelMe-E and ready to receive
a signal.

3.4. Group selection

Push the "Power" switch down, press and hold the "▲" and "▼"
button at the same time and push the "Power" switch to the top.
The "GRP" on the LCD is blinking. Choose the Group number
you desire by pressing the "▲" or "▼" button and then release all
the buttons for longer than 5 seconds to confirm it. The blinking
of "GRP" on LCD stopps and the selected Group number is
displayed.
For TelMe-E; Send the transmission signal of TelMe-T to
TelMe-E after set the Group number you desire on theTelMe-T.
Turn on the power of TelMe-E by press the "Power" button
longer than 2 seconds.
English 15