Advantage 200LS Instructions page 8

and disinfected after every use with MSA
non-sudsing Confidence Plus® Cleaner (P/N
10009971). Rinse thoroughly in plain warm
water (110ºF to avoid possible overheating
and distortion of parts) and then air dry.
ANSI suggests that users should be trained
in cleaning procedure.
Cleaning and disinfecting at or below
110ºF temperature will avoid possible
overheating and distortion of parts which
would require replacement.
DESCRIPTION
CAUTION
MAINTENANCE
This respirator must be kept in good condi-
tion to function properly. When any respira-
tor shows evidence of excessive wear or
damage, it must be replaced immediately.
Refer to the Preparations for Use section for
proper inspection of the respirator. This res-
pirator, when not in use, should be stored in
a clean, dry location, such as its storage
bag. Do not distort rubber facepiece during
storage. When disposing of the respirator or
its components, do so in accordance with
local, state, and federal regulations.
8