1.4 Power Supply
Before connecting the power supply, make sure that the power supply matches the rated
power supply of the product.
Cable Selection of the Protection Device
Residual-current circuit breaker
Breaker
Rated residual leakage current
Power Cord(MM2)
Note: The above data is adapted to power cord ≤ 10m. If power cord is>10m, wire diameter
must be increased. The signal cable can be extended to 50m at most.
Pay attention:
Please ensure the safety of
the power plug.
Otherwise, it could cause
electric shock or fire.
After all connections are complete and checked, perform the following steps:
1) The user should start the water pump first to ensure no water leakage in the water pipe
system; then set the thermostat at the appropriate temperature after power on.
2) In order to protect the machine, it has a delayed start function, after start up, the water
pump start, next fan runs, and the compressor will start up automatically after about 3
minutes
3) Check if there is any abnormal noise when running
Model
Fuse
※ Above data is subject to modification without notice.
Do not disconnect the power
supply while the machine is
running
Otherwise, it could cause an
electric shock or fire.
1436_103460 1436_103459 1436_103283
4.5
30
4.5
3×1.5
6
4.5
4.5
30
30
4.5
4.5
3×1.5
3×1.5
Do not use damaged or
substandard wires.
Otherwise, it could cause
an electric shock or fire.