Tripp-Lite SmartOnline SU750RTXLCD2U Manuel Du Propriétaire page 17

Operation
LCD Status & Supported Measurements
1st screen
  
 
2nd Screen
  
  
3rd Screen
  
 
4th screen
  
  
5th screen
  
  
6th screen
  
 
7th screen
  
 
8th screen
  
 
9th screen
  
 
* Set of 9 information screens are shown in ON LINE MODE, but can also be viewed from all 6 operating modes.
13-11-176-93-3156.indb 17
The LOAD data screen specifies the amount of power that
connected equipment is currently using in terms of percentage and
kW / kilowatts (1kW = 1000 watts / 0.5kW = 500 watts, etc.).
The OUTPUT LOAD LEVEL screen indicates the load percentage and
kVA output load level.
The OUTPUT LOAD POWER FACTOR screen indicates the power
factor of connected equipment.
The INPUT VOLTAGE & FREQUENCY screen displays current data.
The OUTPUT VOLTAGE & FREQUENCY screen displays current data.
The BATTERY voltage screen tracks the charge level of your
connected battery bank in terms of voltage and charge percentage.

The RUNTIME remaining screen tracks the approximate minutes
of runtime available under the current loading and battery pack
configuration. The runtime value will automatically re-calculate as
connected equipment power consumption changes.
The REMAIN WATTS screen tracks the remaining capacity of the
UPS in kilowatts. (1kW = 1000 watts / 0.5kW = 500 watts, etc.).
The DEMAND ENERGY screen offers continuous data on the KWh
(kilowatt-hours) that connected equipment has consumed in the
last one-hour period.
17
PRESS TO ADVANCE
PRESS TO ADVANCE
PRESS TO ADVANCE
PRESS TO ADVANCE
PRESS TO ADVANCE
PRESS TO ADVANCE
PRESS TO ADVANCE
PRESS TO ADVANCE
PRESS TO ADVANCE
11/27/2013 4:24:52 PM