Temperature Guide - Morphy Richards POWER STEAM ELITE 42221 Instructions

Temperature guide

Heat setting markings on the adjustable control dial of all Morphy Richards irons match those of the International Textile Care Labelling
Code.
Symbol
Control dial Do not
positions iron at all
Steam level
setting
Fabric
Ironing
Steaming
Without Steam
Using the Steam Generator for steam ironing
1 If steam ironing, remove the detachable water tank (8), lift the
filling cap (7), and fill with water to the max fill line. Replace the
water tank.
2
Plug the appliance into a mains outlet and press the On/Off
button (16) to activate the unit.
3 Turn the temperature dial (3) to suit the garment (see Temperature
guide). The temperature indicator light (5) illuminates until the
temperature is reached. Begin ironing when the temperature
indicator light (5) goes out. If you turn the temperature dial (3)
down, wait until the temperature indicator light (5) illuminates and
then goes off again.
4 Press the relevant steam button (20/21/22) to select desired steam
level. The steam button will stop flashing and illuminate constantly
when the steam level is reached.
For a strong, continuous flow of steam during ironing, press
and hold the steam trigger (2) to deliver steam through the
soleplate.
WARNING: The steam supply cord (23) will get hot during use.
Steam boost button
(certain models only) 5
The steam boost function is ideal for relaxing the fibres of
tougher fabrics (like jeans and linen) and getting rid of those
stubborn, hard to reach creases.
To produce a quick, powerful shot of steam during ironing,
simply press and release the steam boost button (1).
(120˚C Max) Cool (160˚C Max) Warm
Low Medium/High
Nylon, Acetates Wool, Polyester
synthetic fabrics mixtures
Iron on wrong side
if moisture required
use damp cloth
(Not Acetate)
NOTE: After using the steam boost function, your steam
generator iron will require up to 5 seconds to reheat before it
can produce a second boost of steam. If you require a high
level of constant steam, choose the appropriate steam level and
use the steam trigger (2) as instructed above.
Do not combine the two steam functions. Using the two
buttons together will interrupt the flow of steam and may result
in the constant steam cutting out completely. For optimum
steam output, use each steam function separately and as
detailed above.
Filling
• IN HARD WATER AREAS, WE RECOMMEND A MIX OF 50%
TAP WATER AND 50% DISTILLED OR DEMINERALISED
WATER.
• Never use battery topping up fluid or water containing any
substances like starch, sugar, fragrant additives or defrosted
water from a refrigerator.
Re-filling during use
• If the water level is too low, the low water level indicator light (18)
will illuminate, a buzzer will sound, and the unit will not produce
steam. If this happens, disconnect the water tank and refill with
water.
(210˚C Max) Hot MAX setting
High
Cotton, Linen
Rayon, Rayon
mixtures
Fabrics requiring this
setting usually require
steam pressing
6
g
f
p
i
≈
t
k
5